[TRNSYS-users] Trnedit and parametric runs, trnsys output modification

[C.ARBOLEDA@sanden-europe.fr]

hi,

I'm trying to simulate a DHW system,
and I would like to make a parametric run using TRNedit. 
In this parametric study, I would like
to change the node of my storage tank which is use to regulate my DHW system.

In TRNedit, the TRNSYS outputs are referenced
like this: [Unit#, Output#]
Is it possible to replace the Unit#
or the Output# by a constant or an equation? 

Example:

TANK: UNIT
35 TYPE 534

[35,21] is the temperature of the 1st
node of my tank

I want to replace [35,21] by [35,x],
x will vary every new simulation following my parametric table.

I do not undertand very well the properties
of the object:  [Unit#, Output#]

If it's not possible is there another
solution to this problem?

Thank you in advance for your answer

Carlos Arboleda