I'm using the example PV file to simulate
an array with 288 Sharp NE170U1 panels. I've taken the
example file, input the module parameters into the EES which
seemed to run okay, but I get an error after the EES runs (I
multiplied the Temp Coefficient of Isc by the short circuit
current to reflect units requested in the EES). The EES
updates the Type parameters with the calculation results.
I've updated the module area, # series (12), # parallel (4),
for a total of 48 modules per inverter in both the Type and
the example's Parameters equation. I've input the inverter
performances curves into a txt file, following the format
provided in the type reference. Upon running, the PV type
(194) reports that it's expecting 24 parameters while 29 are
specified, as if there's 24 Parameters in the pro-forma, yet
there are 29. I'm currently using TRNSYS 16. Any pointers
would be appreciated.
Kent Beason
Estes, McClure & Associates, Inc.
3608 West Way
Tyler, TX 75703
-------------------------
office - 903 581 2291
cell - 830 609 8904