[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TRNSYS-users] Type94a - multi array will be wrongly calculated



Olaf,
 I have used multiple instances of Type94 to compute the output of differently oriented PV arrays a number of times and have gotten good results so I suspect that there may be a problem in the way the model has been defined. One complexity of Type94 is that it has two power outputs; one that gives the power at the maximum power point (and therefore assumes that the array is equipped with a maximum power point tracking (MPPT) device) and another that gives the array power at a particular load voltage. This second output is used for direct-connected systems that do not have an MPPT and in this case, the load voltage is an input to the model. Make sure that you are looking at the maximum power point power when you compare the output of the three arrays; otherwise, the problem may be that the load voltage on the array is so low that the power output of the array is minimal no matter what its orientation.  If you are unable to find the solution then I would recommend that you send your project to your distributor for further assistance.
Best,
 David


On 1/8/2013 03:12, Olaf Scholz wrote:

I created a PV collector field consisting of three fields (type 94a) for 3 incident directions (east, south, west) all 94a- modules are connected tot o a type109 weather generator. The total incident radiation for the three directions seems to be calculated correctly (output of type109 for three different surfaces). But the power output of the PV modules seems to be always the same, which is not correct. Do you have a solution for that ?

It seems to be the used input variable in type 94a is always the same, so that only the last value is used for the calculation.

 

Olaf

 



_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://mailman.cae.wisc.edu/listinfo/trnsys-users

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com