I have a question about straight duct. Which height I have to enter on the extrenal side of the building. To the end of the duct (exit of duct -A) or to the same place where determines the height in the room ( beginning of duct-B) .
In situation A , when I choose outputs for straight duct and I save the file this shows up :
and information in *inf file:
COMIS MESSAGE ***** NOTE *****
&-NET-LINks: LinkID=L153 Type=DS_001 FROM(zone MIESZKAA)=3.13 m TO(zone
EN_005)=14.6m deltaH=11.47m. ZoneHeight+LinkHeight is different for sides
FROM & TO, like a vertical shaft. Is this OK ?
Thanks for any help.
Ola Kaczmarek