Dear Michael,
I recommend that you read the following tutorial about going from Energy Rate Control (with the QHEAT output; not dependent on hvac equipment components) and implementing temperature level control (with thermostats and equipment) in your TRNSYS Simulation.
http://sel.me.wisc.edu/trnsys/downloads/tutorials_and_examples/tlc_tutorial17.pdf
Best regards,
Matt Duffy
On 2012-10-11 03:13, Michael Diekerhof wrote:
Dear all, I am looking for a way to simulate an external heating source (Air to water heat pump - Type 401) in combination with Type 56. I would like to plot the heat pump´s COP and its compressor power according to QHeat of type 56. My basic Idea was to connect the weather data to the type 56 and type 401 first and then type 401 to the building. My problem is, that i dont know how to input an external heating source in TRNBUILD. Of course i adjust a roomtemperature which results in Qheat which has to be covered by the heat pump. But where can i tell type 56 that its heating source is the heat pump ??? I am thankful for any suggestions. Michael _______________________________________________ TRNSYS-users mailing list TRNSYS-users@cae.wisc.edu https://mailman.cae.wisc.edu/listinfo/trnsys-users