[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TRNSYS-users] Zeros for the Ground Temperatures



Dear TRNSYS Users,

Please ignore my question regarding the zero ground temperatures. I
figured it out.

Thank you very much,

Best Regards,
Simge Andolsun
PhD Candidate
Texas A&M University
College of Architecture


On Fri, Sep 21, 2012 at 10:52 AM, simge andolsun
<simgeandolsun@gmail.com> wrote:
> Dear TRNSYS Users,
>
> I was modeling the slab-on-grade heat transfer of a seven zone
> building using the Type 1255 mode of TRNSYS. I realized that TRNSYS
> reported zeros both for the ground temperatures and for the floor heat
> transfer of the 7th floor.I suspect this problem is due to an input
> reading or output reporting limitation of one of the types I used in
> my model, but I could not figure out which one. I used two Type 9s in
> my model. One Type 9  was for the zone air temperature inputs of the
> seven zones and one for the floor inside convection coefficients of
> the seven zones. I had sent the files attached to my previous email
> but they were rejected due to the file size. If you could provide me
> another email address, I would definitely send you the input files.
> Would you please help me figure out what might be the reason that
> causes the 7th floor to show 0 temperatures?
>
> I look forward to hearing from you,
> Thank you very much in advance for your help,
>
> Best Regards,
> Simge Andolsun
> PhD Candidate
> Texas A&M University
> College of Architecture