[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] Zeros for the Ground Temperatures

Dear TRNSYS Users,

I was modeling the slab-on-grade heat transfer of a seven zone
building using the Type 1255 mode of TRNSYS. I realized that TRNSYS
reported zeros both for the ground temperatures and for the floor heat
transfer of the 7th floor.I suspect this problem is due to an input
reading or output reporting limitation of one of the types I used in
my model, but I could not figure out which one. I used two Type 9s in
my model. One Type 9  was for the zone air temperature inputs of the
seven zones and one for the floor inside convection coefficients of
the seven zones. Please find the attached files. Would you please help
me figure out what might be the reason that causes the 7th floor to
show 0 temperatures?

I look forward to hearing from you,
Thank you very much in advance for your help,

Best Regards,
Simge Andolsun
PhD Candidate
Texas A&M University
College of Architecture

Attachment: 120920_BaseCaseHabHumMultiSpaceHouse.tpf
Description: Binary data

Attachment: 120913_BaseCaseHabHumMultiSpaceHouseFloor_Soil Noding File.dat
Description: Binary data

Attachment: USA_TX_College.Station-Easterwood.Field.722445_TMY3.epw
Description: Binary data

Attachment: 120920_BaseCaseMultiSpaceHabHumHouse_FlrIntConCoeff0.plt
Description: Binary data

Attachment: 120920_BaseCaseMultiSpaceHabHumHouse_ZoneAirTemps0.plt
Description: Binary data