Dear ALL !,
I got weather data from
measurements (total radiation on horizontal) with the 10 min
interval for ONLY one month (June). I was using type 9e (10
min interval, mode 3) to read the data and type 16a for
radiation processing.
When I set “simulation
time step” in Control Cards to a string “TIMESTEP” and tried
different values in EQUATIONS:
-
TIMESTEP=1/6
(10 minutes) – I got an error in type 16, that “The
simulation time is outside the data reading interval…”
-
TIMESTEP=0.125
(7.5 min - default) - results were wrong but the simulation
went ok.
Connections “Time of
last read” and “Time of next data read” are set properly,
according to the provided example.
What would be the best
to properly set this simulations ?
Is this an issue with
the type 16, which takes one hour (only ?) intervals and
interpolates to required interval given by user ?
I would be grateful if
someone could point out any solution.
Kind regards
Michal Klimas
Poznan University of
Technology