Dear all, I am having two problems. I have a measured hourly domestic heat loads for a year, I would like to implement it in TRNSYS simulation. Which component is best for this application? And how to actually implement it? Also, I would like to utilise air-water heat pump. However, I want to turn the heating mode on only, and completely turn off the cooling mode. How could I achieve this? I would like to set room temperature at 22oC. I would want to turn on the heat pump at temperature below 20oC and turn it off when room temperature arrives at 24oC. I notice there are a few controllers are capable to do this, however, which one is the easiest in controlling this function? Thank you very much in advance. Zhe Li Tá an teachtaireacht seo scanta ó thaobh ábhar agus víreas ag Seirbhís Scanta Ríomhphost de chuid Seirbhísí Faisnéise, ITBÁC agus meastar í a bheith slán. http://www.dit.ie This message has been scanned for content and viruses by the DIT Information Services E-Mail Scanning Service, and is believed to be clean. http://www.dit.ie |