Re: [TRNSYS-users] simulating a PV/T concentrator

["Mehdi Shahrestani" <mahdishahrestani@gmail.com>]

Hi

 

My thought on this issue:

1- the deata file is not properly linked into the component

2-if the component is a new developed, might some parameters (calling exteernal data files) are misses. Have a look on section 7.4.4 of the programmers guide.

3- logical number is not defined in the performa (If it is new component)

 

Hope it helps

Mehdi

---

From: trnsys-users-bounces@cae.wisc.edu [mailto:trnsys-users-bounces@cae.wisc.edu] On Behalf Of Mahdi Hedayatizadeh
Sent: 25 May 2012 11:35
To: trnsys-users@cae.wisc.edu
Subject: [TRNSYS-users] simulating a PV/T concentrator

Hi,

I am simulating a PV/T concentrator through TRNSYS and 
while I run it, I face a message of " Unable to open the file associated with 
an ASSIGNED logical unit number " which I think is relevant to SOLCEL 
subroutine. As I search to find the subroutine source, there is no use! 

Has anyone of you worked with PVT concentrator component in TRNSYS yet 
or faced the same problem?

Best wishes,
Mahdi


 
-- 
Mahdi Hedayatizadeh 
Ph.D. Candidate,
Energy in 
Agriculture,
Department of Agricultural Machinery Engineering, 
Faculty of 
Agriculture,
University of Tabriz,
Tabriz, Iran.
Tel.: +98 
9384772799,
Email: hedayatizadeh@tabrizu.ac.ir