|
Michael, I quickly checked the code. Unfortuantely, the error message doesn't show the
surface ID, but the "order" number of the surface. 28 means it's the 28th surface in the
b17 file. It will be changed to the surface ID. However, in your B17 you have a window OBERLICHT
defined as followed WINDOW OBERLICHT WINID=11004 : HINSIDE=VERTICAL : HOUTSIDE=VERTICAL : and in the airnode described it has the Category=
EXTERNAL Thus, the BACK surface is NOT a surface of an airnode (it
is facing ambient conditions) and may cause error. Best regards, Dipl.-Ing. TRANSSOLAR: KlimaEngineering - Technologien für energieeffizientes
Bauen und Nutzerkomfort in Gebäude Munich - New York - Stuttgart + 49.711.67976.0 Transsolar Energietechnik GmbH, Curiestrasse 2, 70563 Stuttgart Amtsgericht Stuttgart - HRB 23347, Steuernummer 99073/00911, USt-IdNr.:
DE152272639 Geschäftsführer: Dipl.Ing. Matthias Schuler, Dipl.Ing. -----Ursprüngliche Nachricht----- Dear TRNSYS users, I am trying to use a built file for a simulation but each time I am trying to run the simulation it I get following message: "Error in automatic heat transfer calculation for surface 28 or
its adjacent surface! automatic heat transfer calculation is only allowed
on surfaces within a zone. Please check building input file (bui)." ..and I checked the building input file but even if I delete surface 28
I get the same message. I also excluded that the dck file might be wrong... My deck file works with other bui files properly.. I could really use some good advice here ! :) -- Michael Döbele michael.doebele@hochschule-bc.de |