[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] Condensation problem



Dear all,

 

I’m working on a fish factory project located in Nigeria.

I need to simulate the building based on the outside temperature (around 30°C) and the required temperature inside the factory (the temperature level depends on the room but will vary between 13°C and -40°C).

I set the internal gains (lightings, fish, workers, water cleaning), insulation thickness…there is no ventilation and I considered an infiltration factor for each room.

I simulated the building and got the energy needs of the building to provide all the cooling demand.

 

I realized that I considered as main output the sensible cooling demand for the building.

Problem: The relative humidity of the outside air (entering the building when fish load goes in or out) is high in Nigeria (between 60 and 90%). Therefore when fresh air enter the building, the temperature decrease and the relative humidity reach 100% really quickly. There is condensation and thus heat release (latent heat). This amount of heat is high specially when the outside air (around 30°C) has to reach a temperature of -40°C!

 

I decided to analyse the TRNSYS output: QLATG (latent energy gains including ventilation, infiltration…). Then I’ve compared it with the sensible heat and I noticed the following:

Sensible heat =10000 x Latent heat.

I was expected that the latent heat would have been about the same as the sensible heat (calculation done with a mollier diagram).

I decided to check the relative humidity inside the rooms: the relative humidity is almost always at 100%.

 

Question:  I’m wondering if TRNSYS considers the heat released during condensation. The impact is probably huge on the energy demand of the building.

Does anybody know if TRNSYS can give me the energy which is released when the humidity inside the air is condensated?

I did not fix any humidity level inside the rooms.

 

Thanks a lot for your help

 

Best regards

 

Alexis Fabre

 

 

Description: Description: http://www.3e.eu/img/3E_mail.gif

Alexis Fabre 

Project engineer

Kalkkaai 6
Quai à la Chaux
B-1000 Brussels

T +32 2 229 15 29
G +32 489 77 14 96

F +32 2 219 79 89

 

 

Description: cid:image004.jpg@01CD0EA2.ABE1B880

 

3E sa/nv Headquarters (Invoicing Address)

Vaartstraat 61 Rue du Canal, B-1000 Brussels

 

Visit us at www.3E.eu

Not facing but shaping the changes

 

 

 

SAVE PAPER: THINK TWICE BEFORE PRINTING!

 

This email is strictly confidential and intended solely for the use of the individual to whom it is addressed. Any views or opinions presented are solely those of the author and do not necessarily represent those of 3E. If you are not the intended recipient, be advised that you have received this email in error and that any use, dissemination, forwarding, printing or copying of this email is strictly prohibited.