Kamil,
It is hard to know what might be causing the behavior in your
simulation without seeing your project. I would recommend that you
contact your distributor and send them the *.tpf file so that they
can have a look.
Best,
David
On 8/9/2011 14:33, kamil kolodziejczyk wrote:
Hi
I have modelled a simple SDHW system using type 60d with one
heat exchanger and no auxilary heaters. Single speed pump, solar
collector, 2 pipes, controller and tank. So far everything is
working well, however I have (or it is just my displeasure)one
problem: when I run the simulation the temperature within the
tank doesnt change much, it doesnt response to the solar
radiation and is nowhere close to the temperature leaving the
collector. When the temperature leaving the collector increase
the tank temp goes down.I attached the screen from the
simulation. If someone know solution please help
Kami
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://mailman.cae.wisc.edu/listinfo/trnsys-users
--
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI 53703 USA
P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com
http://www.tess-inc.com
http://www.trnsys.com
|