I have encountered an error when trying to run a simulation with a user written component. The list file indicates the Type has been loaded, then later states that the type cannot be found. See error received below. *** Notice at time : 0.000000 Generated by Unit : Not applicable or not available Generated by Type : Not applicable or not available Message : "Type203.dll" was found but did not contain any components from the input file. There is a Type 203 in the simulation, and then when it is called, it cannot be found. *** Fatal Error at time : 0.000000 Generated by Unit : 2 Generated by Type : 203 TRNSYS Message 105 : A TYPE was called in the TRNSYS input file but was either not linked into trndll.dll or was not found in an external dll. A dummy subroutine was called in its place. Please link the TYPE or remove it from the input file Reported information : Not available The performa uses Type number 203, the dll was written with Type203 on the first line of the code. SUBROUTINE TYPE203 (TIME,XIN,OUT,T,DTDT,PAR,INFO,ICNTRL,*) The dll i stored in the "Release Folder" in the User Lib. Any ideas on how this is happening? Aaron J. Danenberg Graduate Research Assistant Candidate for Master of Mechanical Engineering, September 2011 University of Hartford Dana Hall 103, Research Laboratory 1 200 Bloomfield Ave. West Hartford, CT 06117 M: 203 - 610 - 2509 |