Re: [TRNSYS-users] range check error

["Matt Duffy" <duffy@tess-inc.com>]

Dear Kundert de Wit,

In the control cards, turn on the "Debug mode" to True, and run it again. This should elaborate more on the error that you are receiving.

Best regards,

Matt Duffy

----- Original Message -----
From: "Kundert de Wit" <kwit@dwa.nl>
Sent: Wed, January 12, 2011 10:18
Subject: [TRNSYS-users] range check error

Good afternoon,

 

With THRSYS 16 I am trying to make a fairly complicated simulation. After debugging A=B, B=A warnings and division by zero warnings. I now get error “Range check error” which makes that the simulation is aborted after prompting “An unexpected error was accoutered and THRSYS will abort”.

What can be wrong in my simulation?

 

With kind regards,

Kundert de Wit
Adviesmedewerker

 

Duitslandweg 4 - 2411 NT Bodegraven
Postbus 274 - 2410 AG Bodegraven   
088 - 163 53 90  |  kwit@dwa.nl  |  www.dwa.nl

 Get connected via LinkedIn  |   Volg ons op Twitter

 

---

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://mailman.cae.wisc.edu/listinfo/trnsys-users