Re: [TRNSYS-users] Maximum number of equations

[David BRADLEY <d.bradley@tess-inc.com>]

Maarten,
  The error message suggests that it isn't the number of equations that is the problem but the number of operators in your equations that is limiting you. I've never run into this before! It is strange that the model was working previously and having deleted some equations does not anymore; I suspect that it might be a bad error message due to some other problem and would recommend that you send your input file to your distributor for them to have a look.
Best,
 David


On 10/27/2010 02:43, Maarten Sourbron wrote:

Dear all,

 

In a 20 zone Trnsys/trnbuild-building model I use 350 equations to process the results within the simulation run.  Although this is still below the limit of 500 (is this correct, cfr Programmer’s Guide chapter 8?)

I get an error 24 : “The size of the array which holds the operation codes for EQUATIONS and … has been exceeded.  Try reducing …”.

The strange thing is that the model worked, then I deleted some of the equations and suddenly this error comes up.

I’m working with Trnsys 16.

 

Any suggestions?

 

Regards,

Maarten Sourbron

-- 

Departement Werktuigkunde-Department of Mechanical Engineering 

Katholieke Universiteit Leuven

Celestijnenlaan 300A bus 2421

3001 Heverlee (Leuven)

T : 0032 (0)16 32 28 73

F : 0032 (0)16 32 29 85

E : Maarten.Sourbron@mech.kuleuven.be

 

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com