Dear Mesude, Click on escape key two times. Your
focus in on the old zone, release the focus by pressing escape
mesude bayrakci <mesudebayrakci@gmail.com>
10/04/2010 09:01 PM
To
TRNSYS-users@cae.wisc.edu
cc
Subject
[TRNSYS-users] TRNSYS 3D and shading
Hello,
I tried to create a new shading group tool after I created new zone.However,
an error showed up and said
" Zone should be added at the top level of a SketchUp model"
I tried to do that in difference places, always it says the same error.
Any idea?
Thank you._______________________________________________ TRNSYS-users mailing list TRNSYS-users@cae.wisc.edu https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users
================================================================================================================
DISCLAIMER :
The information in this email is confidential and may be legally
privileged.It is intended solely for the addressee. Access to this email by anyone else is unauthorized.If you are not the intended recipient, any disclosure, copying, distribution or any action taken or omitted to be taken in reliance on it, is prohibited and may be unlawful. When addressed to our clients any opinions or advice contained in this email are subject to the terms and conditions.