I am using TRNSYS 16, after generating the input file and I try to run a parametric analysis in TRNEdit, it gives me an error message "Access violation at address 00404038 in module 'TRNEdt.exe'. Read of address 00000B8C".
Please help, thanks.
From: David Bradley <bradley@tess-inc.com>
To: Rekiya Suleiman <omohu_s@yahoo.com>
Cc: trnsys-users@cae.wisc.edu
Sent: Tue, June 22, 2010 5:06:31 PM
Subject: Re: [TRNSYS-users] Parametric runs
Rekiya,
If you are using TRNSYS 16 then there is an overview of using parametric tables in the volume 07: TRNEdit manual (section 7.1.2). If you are using TRNSYS 17, the same information can be found in the volume 06: TRNEdit manual.
The idea is that you generate your input file in the Simulation Studio and then open and edit it using TRNEdit.
Best,
David
On 6/21/2010 14:09, Rekiya Suleiman wrote:
Hi
I am new to TRNSYS, can anyone put me through from the basics on parametric runs e.g varying parameters such as collector area, mass flow rate and storage tank volume in a solar water heater.
Thanks.
Rekiyat
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users
--
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI 53703 USA
P:+1.608.274.2577
F:+1.608.278.1475
bradley@tess-inc.com
http://www.tess-inc.com
http://www.trnsys.com