|
Hi Sabine, Thank you for your help. I have inspected my system and there is no problem with the names of the outputs or with the number of outputs. And now I think that instead of being a links number problem it could be a number of PID used in the system? Guy THOMAS Subject: RE: [TRNSYS-users] FW: trnsys Date: Fri, 14 May 2010 13:44:00 +0200 From: S.C.Jansen@tudelft.nl To: guytho@hotmail.com Dear Thomas,
There can also be a problem with using the same names for different outputs, or names with more than 10 characters. Also in some of the output plotters (fo example type 23) you cannot have more than 10 outputs plotted, eventhough it is possible to give more than 10 as a parameter.
10 is like a magic number often,
good luck!
Sabine Van: Guy THOMAS [mailto:guytho@hotmail.com] Verzonden: vr 14-5-2010 11:56 Aan: trnsys trnsys Onderwerp: [TRNSYS-users] FW: trnsys Hi everybody, Concerning my problem I also feel that maybe there is too much links in my project? Is there any limitation on the number of links on simulation studio? Guy THOMAS CNAM Student From: guytho@hotmail.com To: trnsys-users@cae.wisc.edu Subject: trnsys Date: Fri, 14 May 2010 09:25:28 +0000 Hi everybody, I have a problem on trnsys simulation studio. I'm controlling various zone of a building and until now i had no problem to see on the online plotter the temperature and the flow rate going on the zones. But now, I've just added one more controlling system for an other zone of the building by doing a copy/paste as I have done for all the others zones of the building until now. Then, I connect the temperature of the zone to the plotter and it run the simulation OK. But, when I add the links between the pid and the plotter to see the flowrate (as I have done for all the others zones by replacing the links on the plotter with the new zone added) and I try to run the simulation I have this message error: "One error was found in the deck chek the listing file for more information" so I try to open the listing file but instead it close my simulation studio file. Does anybody know the reason of this problem? Kind regards Guy THOMAS CNAM student Envie de plus d'originalité dans vos conversations ? Téléchargez gratuitement les Emoch'ticones ! De nouvelles Emoticones sur Messenger ? Téléchargez les Emoticones pâte à modeler ! Vous voulez protéger votre numéro de CB ? Utilisez Internet Explorer 8 |