[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] type 28

To: "trnsys-users@cae.wisc.edu" <trnsys-users@cae.wisc.edu>
Subject: [TRNSYS-users] type 28
From: Henrik Davidsson <Henrik.Davidsson@ebd.lth.se>
Date: Tue, 16 Feb 2010 21:31:24 +0100
Accept-language: sv-SE
Acceptlanguage: sv-SE
List-archive: <https://www-old.cae.wisc.edu/pipermail/trnsys-users>
List-help: <mailto:trnsys-users-request@cae.wisc.edu?subject=help>
List-id: "TRNSYS users mailing list at the Solar Energy Lab, UW-Madison" <trnsys-users.cae.wisc.edu>
List-post: <mailto:trnsys-users@cae.wisc.edu>
List-subscribe: <https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users>, <mailto:trnsys-users-request@cae.wisc.edu?subject=subscribe>
List-unsubscribe: <https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users>, <mailto:trnsys-users-request@cae.wisc.edu?subject=unsubscribe>
Thread-index: AcqvRwHfPng0gRIKSs60W76XCwGRuw==
Thread-topic: type 28

Dear all!

I'm working with type 28a. When I perform an "Energy balance check" the list file prints Maximum Error = 0.0000000000E+000. If I look in the printed output file and perform the same calculation as the operation code (0.05 -1 -2 -3 -4 -5 -6) the result is 4.301 (kWh). How can type 28 deliver two different results using the same numbers?

Best regards

Henrik Davidsson

Energy and Building Design

Lund University

Sweden

e-mail, henrik.davidsson@ebd.lth.se

Prev by Date: Re: [TRNSYS-users] Error Type60 with more than 2 nodes
Next by Date: [TRNSYS-users] Type 534 Heat Exchanger dimensioning
Previous by thread: [TRNSYS-users] Error Type60 with more than 2 nodes
Next by thread: [TRNSYS-users] Type 28
Index(es):
- Date
- Thread