|
Dear, I am trying to couple TRNYS with MATLAB. I installed
TRNSYS 16.0 en Matlab 2007 on my computer. The examples for this coumpling
given by the trnsys software are working perfect. My problem occures when I
want to use the matlab code as an controller (parameter 4 is set to 10). In TRNSYS, I want to control a ground coupled heat pymp
(type 668) with a building (type 56). Based on the return temperature of the
active layers of my building model, matlab has to send a control signal to the
heat pump. Parameter 4 from type 155 is set to 10. So the m-file is
only called after convergence of onther components is reached. Based on the
outdoor temperature, a heating curve and the return temperature of the active
layers; an control signal must be send to the heat pump. This is not working in
my code. Al the outputs are constant during the simulation time. The m-file
reads the inputs correctly, but don't send an output signal. Do you have an
idea what's the problem with the code? Thanks in advance, Jan ----------------------------------------------------------- Ing.
Jan Hoogmartens Wetenschappelijk
medewerker KULeuven Department
of mechanical engineering Division
applied mechanics and energy conversion Celestijnenlaan
300A bus 2421 3001
heverlee BELGIUM tel:
+32 16 32 25 08 fax:
+32 16 32 29 85 |
Attachment:
regelingstooklijn52.m
Description: regelingstooklijn52.m