[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] (no subject)

To: <trnsys-users@cae.wisc.edu>
Subject: [TRNSYS-users] (no subject)
From: "#SEK JUN-YANG#" <SEKJ0001@ntu.edu.sg>
Date: Fri, 15 Jan 2010 23:51:44 +0800
List-archive: <https://www-old.cae.wisc.edu/pipermail/trnsys-users>
List-help: <mailto:trnsys-users-request@cae.wisc.edu?subject=help>
List-id: "TRNSYS users mailing list at the Solar Energy Lab, UW-Madison" <trnsys-users.cae.wisc.edu>
List-post: <mailto:trnsys-users@cae.wisc.edu>
List-subscribe: <https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users>, <mailto:trnsys-users-request@cae.wisc.edu?subject=subscribe>
List-unsubscribe: <https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users>, <mailto:trnsys-users-request@cae.wisc.edu?subject=unsubscribe>
Thread-index: AcqV+qNH1BRDCrw/RBqpJsq+/UMjTQ==

Dear Trnsys users,

I am trying to create an active chilled beam for a typical office space and I would like to clarify the steps that I have tried. Firstly, I created a new layer, which is the cooled ceiling, under wall type manager. After which, I added this new layer to the wall type( Roof). Lastly, I defined the cooled ceiling under each zone. If there is any errors or if I have missed out on any steps I would greatly appreciate any remedies provided. I would also like to find out if I were to model a passive beam, what are the different procedures in modeling. Thank you.

Best Regards,

Sek Jun-Yang

Follow-Ups:
- Re: [TRNSYS-users] (no subject)
  - From: David Bradley <bradley@tess-inc.com>

Prev by Date: Re: [TRNSYS-users] Type 28b - average
Next by Date: [TRNSYS-users] (no subject)
Previous by thread: Re: [TRNSYS-users] (no subject)
Next by thread: Re: [TRNSYS-users] (no subject)
Index(es):
- Date
- Thread