Re: [TRNSYS-users] error message 105 (type 557 en 504: Tess models GSHP)

----- Original Message -----
From: "Joke De Beuckelaer" <jdebeuckelaer@vkgroup.be>
Sent: Mon, January 11, 2010 0:50
Subject: RE: [TRNSYS-users] error message 105 (type 557 en 504: Tess models GSHP)

Dear Matt,

Thanks for your answer.

Component 504 and 557 are causing the errors. So I think I have not the appropriate DLL for the tess library.

Greetings

Joke

De : Matt Duffy [mailto:duffy@tess-inc.com]
Envoyé : samedi 9 janvier 2010 0:46
À : Joke De Beuckelaer; trnsys-users@cae.wisc.edu
Objet : Re: [TRNSYS-users] error message 105 (type 557 en 504: Tess models GSHP)

Dear Joke,

What component (the error should tell you the component unit number and type number) is causing the error? Make sure you have the appropriate DLL for that component.

Best regards,

Matt Duffy

----- Original Message -----
From: "Joke De Beuckelaer" <jdebeuckelaer@vkgroup.be>
Sent: Fri, January 8, 2010 1:36
Subject: [TRNSYS-users] error message 105 (type 557 en 504: Tess models GSHP)

Dear trnsys-users,

I’ve simulated a vertical ground heat exchanger (type 557) coupled at a ground-source heat pump (type 504).

When I run the simulation I’ve got an error message 105 : « A Type was called in the TRNSYS input file but was either not linked into trndll.dll or was not found in an external dll. A dummy subroutine was called in its place. Please linke the TYPE or remove it from the input file. »

I looked at internet for a solution, but there I found that the problem normally occors when defining an input-file of your own. So I don’t understand why I get this error, because they are just types of the tess library.

Does anyone know a solution?

Thanks in advance,

Joke De Beuckelaer
project engineer

_______________________________________________

TRNSYS-users mailing list

TRNSYS-users@cae.wisc.edu

https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users