|
I’ve created a TRNSED distributable and have run into
a problem regarding Type 14 Night Setback. I kept parameters 3, 5, 7, and
9 unlocked so as to include them in the TRNSED distributable, named “ENDOFNIG,
ENDOFNI1, BEGINOFN, BEGINOF1” in the .trd file, resp. However, when
I try to run the TRNSED file, the simulation stops from “illegal variable
name” and refers to these parameter names. Refer to the attached in
which the names are set equal to the value as would be input by the user, in
the top section below “***Model Night Setback (Type 14, Unit 22)”.
In the second section under “Unit 22 Type 14 Night Setback”, you
can see these variable names again with the component parameter names to the right.
The simulation proceeds without problems only when I manually type over these
variable names with the integer value I want them to be (in the .trd file
itself). TRNSED-User-defined variables are done this way for other components
in the same file but there only seems to be a problem with this particular Type
14. Thanks in advance for any help. Kent Beason Schlitterbahn Development Group 830-609-8904 m 830-608-8040 f |
* Model "Night Setback" (Type 14) * * *|* *|* *** Model Night Setback (Type 14, Unit 22) *|* CONSTANTS 4 *|*PARAMETERS VALUES UNITS ENDOFNIG= 6.0000000000000E+00 !Variable definition at left *|End of night set-back |hr|hr|0|1|0.0|24.000|1000 ENDOFNI1= 6.0000000000000E+00 !Variable definition at left *|End of night set-back again |hr|hr|0|1|0.0|24.000|1000 BEGINOFN= 1.8000000000000E+01 !Variable definition at left *|Begin of night set-back |hr|hr|0|1|0.0|24.000|1000 BEGINOF1= 1.8000000000000E+01 !Variable definition at left *|Begin of night set-back again |hr|hr|0|1|0.0|24.000|1000 * UNIT 22 TYPE 14 Night Setback *$UNIT_NAME Night Setback *$MODEL .\Utility Library (TESS)\Forcing Functions\Night Setback (Daily)\Type14i.tmf *$POSITION 496 243 *$LAYER Main # PARAMETERS 12 0 ! 1 Midnight 1 ! 2 Control signal-1 ENDOFNIG ! 3 End of night set-back Manual overtype to left with above ENDOFNIG integer value eliminates problem 1 ! 4 Control signal-2 ENDOFNI1 ! 5 End of night set-back again Manual overtype to left with above ENDOFNI1 integer value eliminates problem 0 ! 6 Control signal-3 BEGINOFN ! 7 Begin of night set-back Manual overtype to left with above BEGINOFN integer value eliminates problem 0 ! 8 Control signal-4 BEGINOF1 ! 9 Begin of night set-back again Manual overtype to left with above BEGINOF1 integer value eliminates problem 1 ! 10 Control signal-5 24 ! 11 Midnite 1 ! 12 Control signal-6