Re: [TRNSYS-users] New component / changing number of variables in CVF

[knut.erik.enerstvedt@niva.no]

Mathaeus,

I the number of outputs in the source
code matches the number of outputs in the Proforma, then you should see
the correct number of outputs when using your new component in the Studio.
Make sure that you set Role to "output" when you define the new
variable in the Proforma. You can click on the Outputs tab (after clicking
on Variables) to see a list of all output variables.

Hope this helps,

Knut Erik  




Dear all,
 
I am programming a new type for TRNSYS
using Compaq Visual Fortran (cvf) and I would currently like to add some
outputs. I already changed the number of outputs in the fortran environment
to 
 
1)      NOUT=2,
2)      I performed a simple
calculation, eg a=2,
3)      and set an output
as OUT(2)=a .
 
After recompiling still no changes appeared
so I decided to extend the number of variables in my trnsys type environment
(performa).
 
Even though, no changes appear – there
is only one output available in the TRNSYS project environment.
 
Does any of you know an appropriate solution?
 
Sincerely
 
Mathaeus
 




------------------------------------------------------------------------------------------------------------
Meld deg på vårt nyhetsbrev på www.niva.no