[TRNSYS-users] Segmentation

[Matias Garcia <matias.garcia0@gmail.com>]

Hi to everyone,

I have a problem with the function segmentation of an active layer in type 56b. I have already made a deck to study the influence of the concrete core activation in a room, in this deck type 56 simulates a room with 40 m² that uses segmentation (dividing the active layer in two segments). When I try to load another room with different geometry but same outputs and inputs (this time smaller, 29 m²) I obtain the following the problems:
-segmentation doesn´t work because the minimum flowrate of the first segment is always bigger to the min.desired inlet mass flowrate. when I make bigger the minimum desired flow rate I have no segmentation, which takes to the second problem:
-when I don't use segmentation and run the simulation or try to edit the building from the deck, a message appears with a stop sign and saying "wall of autosegmentation not found"
After this I can't no longer open my bui. file, neither from the deck nor direct from TRNbuild.

can anybody help me?

Thanks a lot.

Matias Garcia

Ansprechpartner/Contact:	Matias Garcia
Bereich/Division:	Versorgungstechnik
Email:	m.garcia@hl-technik.de
Telefon/Phone:	+49 89 992910-19
Fax/Fax:	+49 89 992910-28
GSM/Mobile:
	HL-Technik Engineering Partner GmbH  Sitz der Gesellschaft: Aidenbachstr. 52 · D-81379 München · Telefon +49 89 724061-0 Büroadresse: Feringastr. 10 b · D-85774 Unterföhring
	Geschäftsführer: Prof. Dr.-Ing. e.h. Klaus Daniels
	Registergericht: Amtsgericht München, HRB 175055
	http://www.hl-technik.de · info@hl-technik.de