[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TRNSYS-users] energy for surfaces
Dear Hyokeun Hwang,
The NTYPE, QCOMO, is the rate of energy transfer from the outside surface
to the outside or boundary. We use this NTYPE for our latest TESS slab and
basement models that are coupled to the ground.
Best regards,
Matt Duffy
----- Original Message -----
From: "Hyokeun Hwang" <hyokeun.hwang@gmail.com>
Sent: Thu, May 21, 2009 2:00
Subject:[TRNSYS-users] energy for surfaces
Hello!!!!
Recently, I got a heating/cooling load for the single zone.
And then, I want to know detail energy flow for surface.
So, I was reading a section of 6.2.3.5.6. BALANCE 4(NTYPE 906) at the
Trnsys16 manual.
But, I don't understand for each components, such as DQwalldt, QCOMI, QCOMO.
I need a equation about these components because of to know detail energy
flow.
Thank you for give me the solution.
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users
----- End of original message -----