Dear sir,
I'm a Belgian student and I have a problem to simulate a air-to-air heat pump. I use the type 665. The simulation works but there is a strange gap in the graph when the heat pump switch on and switch off. I have introduced the outlet temperature of the pump by using the type ventilation in Trnbuild. The building is a multizone building (2 zones, dowstairs and upstairs) and I have a lot of questions about the coupling when the pump is on. I have attached a picture to show the problem.
Could you help me? All apologies for my bad English.
Thank you very much.
Best regards.
François Leurident
Student (ingeneer in architecture)
"Faculté Polytechnique de Mons, Belgique"
I'm a Belgian student and I have a problem to simulate a air-to-air heat pump. I use the type 665. The simulation works but there is a strange gap in the graph when the heat pump switch on and switch off. I have introduced the outlet temperature of the pump by using the type ventilation in Trnbuild. The building is a multizone building (2 zones, dowstairs and upstairs) and I have a lot of questions about the coupling when the pump is on. I have attached a picture to show the problem.
Could you help me? All apologies for my bad English.
Thank you very much.
Best regards.
François Leurident
Student (ingeneer in architecture)
"Faculté Polytechnique de Mons, Belgique"
<
Windows Live vous offre des produits 100 % gratuits !
