Hello,
I am currently trying to simulate a water-water heat pump coupled with a solar collector providing hot water on the load side inlet.
The solar collector is composed of EPDM tubes as shown in the attached picture.
I was thinking of using type 668 (water-water heat pump) but the choice for the solar collector is not that easy.
Does someone know what is the most suitable type for this case ?
If not, Can someone send me the missing descriptions of types 564 (Theorical fin/tube solar collector - pool heater) & 538 (Evacuated tube solar collector) ?
<<solar collector.JPG>>
Best regards,
Romain HUCHEDÉ
--
Tel : 02.35.14.40.77
Fax : 02.35.14.49.54
-- Les donnees et renseignements contenus dans ce message sont personnels, confidentiels et secrets. Toute publication, utilisation ou diffusion, meme partielle, doit etre autorisee. Si vous n'etes pas le bon destinataire, nous vous demandons de ne pas lire, copier, utiliser ou divulguer cette communication. Nous vous prions de notifier cette erreur a l'expediteur et d'effacer immediatement cette communication de votre systeme. Any data and information contained in this electronic mail is personal, confidential and secret. Any total or partial publication, use or distribution must be authorized. If you are not the right addressee, we ask you not to read, copy, use or disclose this communication. Please notify this error to the sender and erase at once this communication from your system.
Attachment:
solar collector.JPG
Description: solar collector.JPG
