Re: [TRNSYS-users] Type 56 - surface energy balance (NTYPE 906)

["hotline" <hotline@transsolar.com>]

Maarten,

balance outputs are different then the other outputs of TYPE 56. All balance outputs are printed into files only. The values aren't avaliable within the TRNSYS input file for
further usage. This will be changed for the next version.

Marion 
TRANSSOLAR TRNSYS Team

-----Ursprüngliche Nachricht-----
Von: Maarten Sourbron [mailto:maarten.sourbron@mech.kuleuven.be] 
Gesendet: Donnerstag, 27. September 2007 12:11
An: trnsys-users@engr.wisc.edu
Betreff: [TRNSYS-users] Type 56 - surface energy balance (NTYPE 906)


Dear Trnsys-users,

Trying to check the energy balance for a simple room (with active floor 
and active ceiling), I found out that, when I request NTYPE 906 (energy 
balance for surface) as output in TRNBUILD, this output is included in 
the list of the .BUI-file, but not in the .BLD-file.  Therefore I can 
not use it in the trnsys-file as an output.
I assume it is some kind of syntax-error, does anyone know a solution?

Kind regards,

Maarten Sourbron

-- 
-----------------------------------------------------------------------------------------------
Maarten Sourbron
Department Mechanica, afdeling TME
K.U.Leuven
T : 016 32 28 73
F : 016 32 29 85
email : maarten.sourbron@mech.kuleuven.be
-----------------------------------------------------------------------------------------------



Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@engr.wisc.edu https://www.cae.wisc.edu/mailman/listinfo/trnsys-users