Re: [TRNSYS-users] Problem with Type 60

["Diego A. Arias" <daarias@wisc.edu>]

Hi Samuele,
I could not run your file because some data files were missing.
I would recommend that you start with a simple simulation with only a 
few components, and check if you still see this behavior.
Best regards,

Diego


Samuele wrote:
> Dear all,
>  
> I have noticed a problem with Type 60: I fix the number of nodes to 
> consider the stratification but, as you can see in the online plotter 
> or in the results
> of the printer, the top and the bottom temperature are always the same 
> and , moreover, the temperature of any other nodes is always 0°C.
>  
> Could anybody tell me if there is a problem with this type?
>  
> There is the project enclosed. 
>  
> Thanks in advance,
>                                    Samuele.
> ------------------------------------------------------------------------
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users@engr.wisc.edu
> https://www.cae.wisc.edu/mailman/listinfo/trnsys-users


--
Diego A. Arias
TRNSYS Coordinator
Solar Energy Laboratory
University of Wisconsin - Madison
1500 Engineering Drive
Madison, WI 53706