[TRNSYS-users] "Link" trouble between two components.

["Bryan Choi" <ukmaster2@gmail.com>]

Hello.

I am a beginner with TRNSYS, and am doing pracrtice with the manual and my simple model.

 

I followed the manual to link two components as it said "When you move the mouse over a component icon, the 8 available connection
points become visible. Click one one of them to select the starting point, then go to the component you want to link and select a connection point again. Click to create the link".

 

I can see the 8 available connection points after clikcing the Link icon. But, when I click one of them to select the starting point, the points are disappeared.  I think every configuration has no problem, right orders, right configuration of each component, etc.except this  trouble.  

 

Could you give me any advice or solution about the Link trouble?

 

Thank you.

 

Choi

 

 

 

 

Components are connected using the Link tool, which is activated by pressing the link button (see
 

Figure 1–24). When you move the mouse over a component icon, the 8 available connection
points become visible. Click one one of them to select the starting point, then go to the
component you want to link and select a connection point again. Click to create the link. The
newly created link is empty, i.e. it does not connect any (output; input) couple yet. This is shown
by a different link color (blue by default, while links with connections are black).