[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TRNSYS-users] Using output of equations as a parameters
Mohammad,
Yes, you simply enter the name of the equation as the parameter value.
If you are using the TRNSYS Studio you need to change the units of the
parameter to "string" and then type the name of the equation. If you are
using TRNEdit, it might look like:
EQUATIONS 1
MyValue = 13
...
UNIT 5 TYPE 718
PARAMETERS 1
MyValue ...
Bear in mind, though that PARAMETER values are read once at the beginning
of a simulation and are not updated during the simulation. Thus the result
of your equation may change throughout the simulation but the component
parameter value will not be updated.
Kind regards,
David
At 09:17 1/8/2007, mohammad abdunnabi wrote:
Dear Trnsys users
Is it possible to use the output of equations (the output is calculated
from other output compoenets) as a parameters (not input) in other
component in Trnedit. If not, is any way that I can do to use the output
of any compenent as a parameter to other components in Trnedit simulation
program.
many thinks in advance
M. Abdunnabi
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@engr.wisc.edu
https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
****************************************************************************************
Thermal Energy System Specialists (TESS), LLC
David BRADLEY 2916 Marketplace Drive - Suite 104
Partner Madison, WI 53719
Phone: (608) 274-2577 USA
Fax: (608) 278-1475
E-mail: bradley@tess-inc.com
Web Pages: http://www.tess-inc.com and http://www.trnsys.com
"Providing software solutions for today's energy engineering projects"
****************************************************************************************