Re: [TRNSYS-users] Absorption Chiller

[David Bradley <bradley@tess-inc.com>]

Pedro,
  The Type7 absorption chiller model was replaced with hot water fired, 
single effect absorption chiller model with the release of TRNSYS 16. That 
model, as well as single and double effect hot-water fired, direct-fired, 
and steam-fired absorption chiller models are available in the TESS HVAC 
Library for either TRNSYS 15 or for TRNSYS 16.
Kind regards,
 David


At 11:33 10/17/2006, Pedro Silva wrote:
> Dear TRNSYS users,
>
> I´m using an absorption chiller (Temperature Level Control - Type 7a) to 
> get chilled water for a colling coil to supply a building. The primary 
> heat source of the chiller is a hot storage tank.
> My question is how to give the information of the required temperature to 
> cool in the building.
> The outputs of the this type are very limited, so I can't control very 
> well its execution.
> I already tried to put Type 7b (Energy Rate Control), which have as an 
> input the cooling required, and give it the cooling rate with a file in 
> Type9 but the performance wasn't definitely the best.
>
> Thanks in advance!
>
> --
> Pedro Santos e Silva
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users@engr.wisc.edu
> https://www.cae.wisc.edu/mailman/listinfo/trnsys-users

****************************************************************************************
Thermal Energy System Specialists (TESS), LLC
David BRADLEY                           2916 Marketplace Drive - Suite 104
Partner                                        Madison, WI 53719
Phone: (608) 274-2577 USA
Fax: (608) 278-1475
E-mail: bradley@tess-inc.com
Web Pages:  http://www.tess-inc.com     and      http://www.trnsys.com

"Providing software solutions for today's energy engineering projects"
****************************************************************************************