Dear Ray,
Maybe I think too simple,
but can’t you just take Q(t) = U * (Tamb(t)-Tzone(t))? The U of your wall
is given in the wall type manager.
Kind regards,
Stefan de Kool
Van:
trnsys-users-bounces@engr.wisc.edu [mailto:trnsys-users-bounces@engr.wisc.edu] Namens RAJ KUMAR
Verzonden: woensdag 22 maart 2006
19:11
Aan: trnsys-users@engr.wisc.edu
Onderwerp: [TRNSYS-users] about
heat transfer from outside to inside byconduction only.
Hello all,
I want to know the amount of amount of heat transfer from outside surface
to inside surface of wall,
My wall configration is 15mm plaster on eitherside of 220mm brick wall, that's
all.
could you please guide me?, In surface output, which combination (of Ntypes)
should I take to calculate the amount of heat transfer from outside to inside
by only conduction?. There is no active layer in my problem.
I have gone through the balance ouputs given in your manual
(volume6) from page 101 to 105. Cann't we analyse all Ntypes say 901-908 in present version?.
regards,
raj
Yahoo! Mail
Bring photos to life! New
PhotoMail makes sharing a breeze.