Re: [TRNSYS-users] Simulation

[David Bradley <bradley@tess-inc.com>]

Dear Jamyang,
  It sounds as though you could use a Type14 forcing function that has a 
value of 1 from hour 1020 to 1030, then has a value of 0 from 1030 to 1032, 
then has a value of 1 again. You might use the value of the forcing 
function as a control switch on the piece of equipment that turns off for 
those two hours. If there is something in your simulation that makes using 
a control signal difficult, please let me know and I can try and come up 
with a better solution.
  Kind regards,
David

At 06:10 PM 9/29/2004, Jamyang Palden wrote:
> Dear all,
>
> Is it possible to have intermittent simulation....this is mostly 
> applicable in drying applications. For example, start simulation at hour 
> 1020 to 1030, stop for 2 hours and then again start with same time step.
>
> Thanks in advance
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users@engr.wisc.edu
> https://www.cae.wisc.edu/mailman/listinfo/trnsys-users

****************************************************************************************
Thermal Energy System Specialists (TESS), LLC
David BRADLEY                           2916 Marketplace Drive - Suite 104
Partner                                        Madison, WI 53719
Phone: (608) 274-2577 USA
Fax: (608) 278-1475
E-mail: bradley@tess-inc.com
Web Pages:  http://www.tess-inc.com     and      http://www.trnsys.com

"Providing software solutions for today's energy engineering projects"
****************************************************************************************